Worktop finish and thickness

Choose the finish and thickness of your worktop

Worktop measurements

Measure the length (mm) & width (mm) of each worktop piece that you require and input them into the boxes to the right. Also please include any free standing pieces such as islands, breakfast bars etc.

Radius corners

Radius corners are when we cut the stone to follow a rounded corner unit or add shape to a breakfast bar.

Polished cut-outs

These are cut-outs for under-mounted sinks, taps, switch holes etc. that require the inner exposed edges to be polished as they will be visible.

Unpolished cut-outs

These are cut-outs for unfinished edges that will not be visible, i.e. for hobs and surface mounted sinks.

Polished edges

Standard chamfer is included as standard. Other edges are available for an additional fee. Pencil Edge, Shark Nose, Ogee and Half bullnose.

Drainer grooves

These are five straight grooves (1 set) in the worktop at one side of the sink which act as a draining board.

Upstands

These can be used instead of tiling the wall. Measure the total length of upstands required. Normally around 100mm in height.

Windowsills and splashbacks

This is the granite panel that can be used behind hob, range and sink to protect the wall from splashes. You can also have full wall splashbacks which are positioned on top of the worktop to the underside of the wall unit.

Measure the length (mm) and width (mm) of each splashback piece that you require and input them into the boxes to the right.

Templating & Installation service

This is a service where we come out and make a life size template of the worktops. Make it all at the workshop and come back and install them.

Promotion code

If you have a promotion code you would like to apply to your quotation please enter it here.